Garage door won't close: sensor repair in Haworth

A garage door that refuses to close is annoying, but it is the safety system doing its job.

Call (551) 249-6024

In short

A garage door that won't close from the remote is most often a sensor problem, not a broken door. In Haworth, a technician checks the photo-eyes and wiring, resets the travel and force, and confirms the door reverses on contact before leaving. Don't bypass the sensors in the meantime.

Ceiling opener and torsion spring over a single garage door

Doors that won't close in Haworth

Haworth borders the Oradell Reservoir, and on the reservoir side mist and damp air are a fact of life: sensor lenses fog on cool mornings and connections corrode faster than they do inland. Around the country club, larger homes have multi-bay garages with long wire runs. In central Haworth, early-1900s houses have detached garages on narrow lots, used mostly for storage. Toward the Dumont border and the Closter and Demarest side, post-war capes and colonials have compact attached garages. The borough is thick with old trees, and November leaves against the door are the usual seasonal trigger.

What it means when the door won't go down

Every opener made since 1993 has two photo-eyes a few inches above the floor, one on each side of the door. If the beam between them is broken, or the opener cannot tell whether it is, the door will not close from the remote.

  • Blinking sensor light: the eyes are out of line or one lens is dirty.
  • Both lights off: no power to the sensors, usually a wire pulled loose or chewed.
  • Lights steady but the door still reverses: the problem is the close limit, the force setting, or something binding in the track.

What you can safely try yourself

Clear the doorway, clean both sensor lenses, and check that the two sensors point at each other at the same height. A steady light on each side means they can see each other. If one keeps blinking after that, or the wires look damaged, leave it for the technician.

Never disconnect the sensors or move them up out of the doorway to get the door working. They are what stops the door from closing on a child, a pet or a car.

How the repair is done

The technician tests the sensors and their wiring, realigns or replaces them, then checks the close limit and the force setting. Before leaving, the door is tested on a block of wood laid flat in the doorway: it has to reverse as soon as it touches it. If the door itself is binding in the tracks, that is corrected too, since a stiff door is often what set the opener off in the first place.

Around Haworth

  • Dumont border: Southern streets with a mix of older and rebuilt homes.
  • Closter and Demarest side: Eastern streets with newer construction.

See the full Haworth service area.

Door stuck? Call before you try to force it.

Keep people and pets away from a door that's stuck or crooked, unplug the opener, and give us a call.

Call (551) 249-6024
Call (551) 249-6024